Tapered Head Bearings These bearings improve handling and last longer than standard Ural head bearings. When it becomes time to replace worn or damaged stock bearings step up to the smooth and stable tapered bearings, each bearing is pre-packed with a high preasure grease and sealed in a poly bag ready to install. Always Replace Upper and lower bearings as a set. Tapered Head bearings $51.95 a set

Click here for bigger picture of item

Kehien and Mikuni Carberator screw kits/stock compliance fittings No more rust or stripped screws!! Stainless steel all the way. The Kit includes : 4 8x16 socket head screws for the compliance fittings. 8 socket head screws for the Kehien diphram covers 8 socket head screws and lock washers for the Kehien or Mikuni Carbs 1 wrench that fits all the socket screws on the carbs. It also fits the drain in the Kehien carb! 1 wrench that fits the compliance fitting mounting screws. $10.95 for Kehien $ 9.95 for Mikuni

Deep oil sump from the UK . Heavy Duty Sand Cast Aluminum. The UK Dealer has found it holds an additional.75 liter over stock. This will help reduce the oil temp under the same load. The Ural is as much a oil cooled as air cooled. Sunday, June 14, 1998 Ural Tech Department said: "additional cooling can be obtained by adding a half quart of oil during the summer months. As the motor is part splash lubed/cooled, the additional half quart will help!" This is with the stock oil sump. The combination of the additional capacity and additional oil recommended by UA it is more than a QUART increase!!! Hi Capacity Alloy Oil Sump,includes 12 plain steel socket head screws,use your oil plug,order new gasket if needed below . Only $125.00 Stainless Steel Screw set ordered with sump,save $4.00! $ 10.95 Ural Sump Gasket $ 6.50 Magnetic Oil plug and copper gasket $ 9.95 Soft Copper sealing gasket $ 1.05 * 4 to six week delivery and a 20% restocking fee

Click here for bigger pictures!

Click on for bigger picture.

Mikuni Compliance fitting with vacume port and Stainless Steel Socket head screws. No Drilling of the Carburetor body Body!! These will allow the use of a Mercury type or Vacuum gages. Idle can be synced and cable pull just off the idle stops for a balanced throttle response. You can also connect both carbs by means of a balance tube,some people say it will Idle smoother and better low-end. Each Fitting come with new mounting hardware as pictured cost each is $21.95 USD it takes two per machine 1 left 1 right plus shipping or "carriage" for our Commonwealth Friends. Illinois Residents sales tax will be added. Order here!

Magnetic Drain plug and washer, how can you ride without one of these! Drain plugs are only $9.95 Order here!

Complete set of Flat Head Allen screws Case screw kits are only $14.95 Order here!

Set of Ignition Plate Allen Head screws for your Ural Timing plate is only $5.95 Order here!